POPWELD Automated Welding Rotator
Pipe welding roller/rotator
Pipe welding Roller was a turning device which is created to respond a request from the customer who want to turn the small dia. pipe easily.
Unnecessary extra equipment was removed, and the problem for installation & uninstallation are solved. This device suit for the work-field where to weld the small dia. long pipe by minimum equipment easily & promptly.
Features: PR-200X II
• Digital Peripheral speed meter is installed as standard equipment.
• It can hold nearby the welding position, so center runout can be reduced.
• It can be tilted 45 degrees to both left & right, so you can get ideal welding position easily without re-chucking.
• The work piece can be loaded & unloaded from the side, also the work piece can be loaded from the upper side by swiveling the pressure part so that workability is improved very well.
• Roll height was improved 100mm higher than conventional model, so it is easy to work.
• Drive wheel is controlled by inverter, so it provides stable and huge range of speed control.
PR-200X II
• Tilting Left & Right 0-45 degrees
• Roller Cover is installed.
• Dust Tray is installd.
product details
Capacity
*Maximum Load Capacity using outboard roller support 1000 pounds
Maximum Rotation Torque 5000 in-lb
Maximum Pipe Diameter 16 inches
*Model PB1005 must be used with an outboard roller support. Chuck is fixed at
90 degrees to floor and does not tilt.
Rotation
Motor: 1/2 HP DC Variable speed.
Speed Range – Variable from 0.08 to 1.9 RPM
Speed Accuracy – 2 % of base speed.
Rotation Drive – Fully enclosed & lubricated self-locking worm gear.
Chuck – MT16 Gator 3-jaw self-centering
Maximum Outside Diameter gripping 16 inch
Minimum Outside Diameter gripping 0.625 inch
Fixed at 90 degrees to floor
Centerline of chuck to floor 32 inches.
3-jaw self-centering hardened reversible jaws.
RS-15 outboard roller support
Maximum Load Capacity 1500 lbs.
Maximum Pipe Diameter 20 inches
Minimum Pipe Diameter 2 inches
Vertical Height adjustment 9.0 inches
Urethane rolls with sealed ball bearings
Roll to roll adjustment settings - 3
Powder coated frame with 4 anchor bolt holes.
Welding Ground Conduction
– 500 Amps thru spring loaded mechanical ground.
Primary Input power
– AC 115 volts 60 Hz Single Phase 15 Amp.
Controls
External Nema 4X Control box – With Power On, Stop and Overload indicator lights.
Speed Control – One turn potentiometer
Directional Control – Forward/Reverse switch with dynamic braking resistor.
Start Stop Switch – For safety must be used to start if power is lost.
Overload Protection – 8 Amp motor fuse.
Foot Switch – Heavy Duty Remote start/stop with 25 feet of cable.
Cables – All motor, foot control and input power cable Heavy Duty 600 volt.
Frame
– Heavy tube construction powder coated, Qty. 4 anchor bolt holes.